Treatex Colour Tone Ultra

Treatex Colour Tones strike the perfect balance, penetrating deep into the timber to provide an impressively natural finish every time. Utilising natural pigments and sustainable raw materials, Treatex Colour Tones are available in many natural wood colours, so you can match your surfaces without losing the original beauty of the wood.

Choose from Light Oak, Medium Oak, Slate, Pebble Grey,

Please note- These are non-refundable/non-returnable

Suitable for: Internal use
Recommended timbers: Most species of timber
Applications: Floors, doors, stairs, worktops, skirting, furniture, table tops, wood turning, wood toys, instruments

1L will cover approximately 20m² in one coat, depending on the timber and method of application.

Preparation

Start by sanding the surface to smooth bare wood using 80-120 grit sandpaper, ensuring all previous finishes and contaminants are removed. Make sure the surface is thoroughly dried before application and that you have enough Colour Tones Ultra for the whole project. If using multiple tins, it is advised to mix them before use. We recommend a small trial application, as oak colour stains will react differently with various timber species.

Application

1. Roll or brush one coat of Colour Tones Ultra on. Just one coat is necessary as a second coat will only slightly deepen the colour.

2. Remove excess product with a lint-free cloth to ensure even drying. If warmth and ventilation are maintained, drying should take 3-6 hours.

3. Once dry, seal with two coats of Treatex Hardwax Oil Ultra Clear. This will prevent the natural pigments from fading.

Features

• Low Odour

• Meets with VOC emissions regulations

• Easy to apply

• Quick drying